The reason for the problem could be lint, dust and other debris getting stuck in their mechanism. The solution: Stop work, lift the presser foot and thoroughly clean the fee dogs from any debris. Also, make sure that they are lifted up in a raised position allowing for a proper grip of the fabric.
Why does my fabric keep getting stuck in my sewing machine?
A massive nest of tangled thread is usually a result of the sewing machine being improperly threaded. Just because the tangled mess is on the bobbin side of the stitching, don’t assume the fault lies with the bobbin. To correct this problem, put the presser foot up and unthread the sewing machine entirely.
Why does my needle keep getting stuck?
If you do not use the correct size needle for your thread or fabric, then you could run into a jamming issue. Make sure you are using the proper thickness when it comes to your needle based on the fabric and thread you are using. … If you use the wrong needle, the needle can get bent or stuck.
Why is my thread bunching underneath?
Your Thread Tension Is Too Tight
Make sure that you are using the same weight thread in both your bobbin and upper thread. If you don’t, your tension can be uneven and cause you to get bunched-up thread under your fabric. … If your tension is too tight, it can pull your thread and break it.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why won’t my sewing machine needle go up and down?
A disengaged clutch, broken drive belt or internal drive gear failure can prevent the needle from moving. Engage the hand wheel clutch if you have it disengaged for bobbin winding. If the needle won’t move with the clutch engaged, unplug the sewing machine and check the drive belt.
Why does my fabric keep getting stuck in the feed dogs?
Your Needle Is Damaged, Bent, or Dull
Over time, your sewing machine needle can get damaged or bent, especially if you are sewing through thick fabric. If your needle gets too bent, it can hit your feed dogs, throat plate, or bobbin case, and break. It can also push your fabric under your needle plate.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
How do I fix bobbin thread bunching up?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.