Stockinette stitch is a basic knitting stitch. To knit stockinette stitch (abbreviated St st), you alternate a knit row with a purl row. Stockinette stitch (or stocking stitch) is everywhere: scarves, socks, sweaters, blankets, hats — you name it. … The right side is typically the smooth side, called stockinette or knit.
What is the best method of casting on knitting?
The long-tail cast-on method is probably the most popular among experienced knitters. It does take a bit of practice to get this method down, but once you understand what you’re doing it’s quick and easy to get stitches on the needle. Uses: The long-tail cast-on also counts as a row of knitting, which is nice.
Why do my knits look like purls?
The most likely culprit is that you are wrapping your yarn the wrong way around your needle on either the knit side, the purl side, or both. You should always wrap the yarn counterclockwise around your needle.
Did I knit or purl the last row?
Hold your knitting with the point of the needle to the right. If the work is smooth then your last row was purl and you are about to begin a knit row. If the work is bumpy then your last row was knit and you are about to begin a knit row.
What is long tail method in knitting?
To make the loop in a long–tail cast-on, slip the tip of the needle under the thread that is around your thumb (the yarn attached to the ball). Stretch the needle back over the other strands and behind the yarn around your index finger (the long–tail).
What is the advantage of casting on thumb method?
The advantages of the thumb cast on: It creates a stretchy cast on and therefore is suitable for garments that need give e.g. sock and mitt cuffs (a revelation for me as hinted at in the introduction above!) It is simple to do in the middle of your knitting as you continue to work in the same direction.
Why use a long tail cast-on?
The long tail cast on serves to cast on stitches onto the needles and it results in a very flexible rim. It works well in projects where you knit in stockinette stitch or rib stitch at the beginning. In addition, it results in a rim that is both consistent and beautiful.
Should you slip the first stitch when knitting?
First and foremost, unless the instructions indicate otherwise, slipping stitches is always done purlwise. The only way to keep the correct “leg” facing forward in your knitting is to slip the stitch as if to purl, and it doesn’t matter if you are on the right side or the wrong side of your work.