If you knit from the top-down, as a rule of thumb, you’ll need to cast on around 14 or 15 stitches per needle (56 or 60 stitches total) if you have a regular woman’s size and 16 or 17 stitches per needle (64 or 68 stitches total) for a regular men’s size. and then start decreasing at the toe.
How do you figure out how many stitches to cast on?
The Stitches to Cast-On = (dW x S/W). Divide Stitches counted in swatch by swatch Width measured. Multiply by Desired Width. So for the example for the above you will take your 4×4 measured area.
How long should a sock leg be?
The length of the leg of a sock for short socks is “F”, and this usually averages around 6 inches. Use a good stretchy pattern stitch for this. If you are using a lace or more flat knit piece, like intarsia or Fair Isle, be sure and work an inch or more of a stretchy ribbing in the cuff to help keep the sock UP.
How many stitches are in a 10 inch square?
How many stitches you need for a 10 inch square will depend on the thickness of the yarn and the size of the needle, and how tightly you knit. This is a (very) rough guide to how many stitches … Then just keep knitting until your work measure 10 inches/25cm long and cast off.
How to knit a 10 inch/25 cm square.
|Yarn||Approx Needle Size in mm|
What is stitch per inch?
A sewing machine sewing at 5,000 SPM at 14 SPI will sew 9.9 yards of seam per minute. More stitches per inch will also consume for thread per inch of seam. This will contribute to higher seam strength and more elastic seams, but will also increase the consumption of thread required to sew the garment.
What is the best cast on method for knitting socks?
Cuff-down is the most popular way to knit socks. The cast-ons for this method are endless since you can cast on just like you would for any other project. However, there are a few stars among the cast-ons that knitters use again and again.
How tight should socks be?
Find Socks that Fit You
The circumference of your socks should be about one inch smaller than the measurement around the ball of your foot. From heel to toe, your socks should be about one inch shorter than the length of your foot.
Is tubular cast on good for socks?
The tubular cast-on is one of those. It’s very stretchy, so it’s useful for socks, mittens, gloves, and hats. It’s also the perfect beginning for ribbing, which it mimics.
How do you knit a short row heel?
Row 1: Knit to 1 stitch before the end of the heel, wrap and turn. Row 2: Purl to 1 stitch before the end of the heel, wrap and turn. Row 3: Knit to 2 stitches before the end of the heel, wrap and turn. Row 4: Purl to 2 stitches before the end of the heel, wrap and turn.