Why is my bobbin thread looping?

Looping of stitches is sometimes caused by placing the bobbin in the bobbin case the wrong way. Check your machine’s manual for directions on inserting the bobbin. There may be lint, dirt, or thread between tension discs. Check your machine’s manual for ways to carefully remove it.

Why is my bottom stitch looping?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

How do you fix bobbin tension?

To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.

Why does my bobbin thread keep bunching up?

There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly. More than likely, you forgot to put the bobbin back correctly while cleaning your machine.

IT IS INTERESTING:  How do you make carpet out of old clothes at home?

How do I stop my sewing machine from looping?

Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.

Why does my sewing machine keep jamming underneath?

However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.

What tension should my sewing machine be on?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

When should you tighten bobbin tension?

If the tension isn’t perfect, fix it by adjusting the bobbin spring; tighter if the bobbin thread shows on the upper layer, and looser if the needle thread shows on the underlayer. Make another test seam, and examine the stitches, repeating until the stitch is balanced.

My handmade joys