There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly. More than likely, you forgot to put the bobbin back correctly while cleaning your machine.
Why is my thread bunching underneath?
Your Thread Tension Is Too Tight
Make sure that you are using the same weight thread in both your bobbin and upper thread. If you don’t, your tension can be uneven and cause you to get bunched-up thread under your fabric. … If your tension is too tight, it can pull your thread and break it.
How do I stop my sewing machine from bunching?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
Why is my fabric bunching while sewing?
Cause. Tension pucker is caused while sewing with too much tension, thereby causing a stretch in the thread. After sewing, the thread relaxes. As it attempts to recover its original length, it gathers up the seam, causing the pucker, which cannot be immediately seen; and may be noticeable at a later stage.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
What tension should I use for stretchy fabric?
For a stretchy fabric, it would be best if you set the upper tension level between 3-4. This adjustment is also a neutral level of tension setting. Step 5: Now, after you have attached the correct needle, stitch type, and tension setting, it is time to test the final stitch on your fabric.