How do you adjust the bobbin tension on a sewing machine?

To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.

When should I adjust the bobbin tension?

Hang the bobbin case by the thread. If the bobbin case doesn’t move at all when you jerk it the tension is too tight and you need to decrease the tension for sewing with this thread. If the bobbin case drops quickly the tension is too loose and you need to increase the tension.

Why is my thread looping underneath?

Looped stitches are usually caused by improper tension. … Looping of stitches is sometimes caused by placing the bobbin in the bobbin case the wrong way. Check your machine’s manual for directions on inserting the bobbin. There may be lint, dirt, or thread between tension discs.

What number should the tension be on a sewing machine?

As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.

IT IS INTERESTING:  Best answer: Can you use yarn for a hair wrap?

What should my bobbin tension be?

Proper bobbin tension is essential to good embroidery. If tension is too tight, unwanted bobbin thread may begin to show on top of your garment and you may begin to experience frequent thread breaks which wastes time and money. Bobbin tensions should be 18 to 22 grams (up to 25 grams when embroidering caps).

What causes bobbin thread to bunch up?

Bobbin Thread Tangling



The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly.

What is the correct tension for a Singer sewing machine?

The target figure should be around 30 to 40g. (1-1/4 to 1-1/2 oz) but it does not have to be too precise. However most people don’t have a spring balance handy, so alternatively you can tie a weight of the correct amount onto the thread and then jerk the bobbin gently upwards.

How do I fix bobbin thread bunching up?

How to Fix Bobbin Thread Bunching and Other Threading Problems

  1. Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
  2. Change the Needle. …
  3. Inspect the Bobbin. …
  4. Clean the Machine.
My handmade joys