Your stitches are not catching with the thread leaving a big mess to clean up. This issue can be solved by checking the upper thread tension. … Another stitch problem comes when you forget to put the top and bobbin thread under the presser foot. Without this aid, your thread is too free to move about.
Why is my top thread not catching?
Check the upper thread. – Check to see if your upper tension is too tight. … – Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly.
Why is the stitching loose underneath?
Another reason you may experience loose stitches is that the thread tension may be low and may not be tight enough to hold these threads tighter to the fabric. When you experience loose thread, you should readjust your tension to see if it is close enough to stop the loose stitches.
What are three possible causes of skipped stitches?
A dull, bent, or nicked needle can cause skipped stitches. You may not see visible issues with your needle, but try replacing the needle to see if your skipped stitches subside.
Why is my bottom stitch not straight?
If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
Why are my stitches bunching up?
Your Thread Tension Is Too Tight
Make sure that you are using the same weight thread in both your bobbin and upper thread. If you don’t, your tension can be uneven and cause you to get bunched-up thread under your fabric. … If your tension is too tight, it can pull your thread and break it.
Why does my twin needle skip stitches?
Skipping stitches is a common problem with double needles when they become dull or the upper tension is too weak. … There are special twin needles for knit fabrics, for woven fabrics, for jeans, for decorative embroidery stitches. 4. Sometimes the 2 thread spools should be unwinding in opposite directions.
Why are my stitches looping?
Causes of Stitches Looping
Looped stitches are usually caused by improper tension. … Looping of stitches is sometimes caused by placing the bobbin in the bobbin case the wrong way. Check your machine’s manual for directions on inserting the bobbin. There may be lint, dirt, or thread between tension discs.
How will you regulate the length of the stitches if you notice that the stitches are skipping?
When the stitches randomly start skipping, change your needle. If the stitches return to normal, then the problem was a bent needle. It can be caused by such things as tugging too hard on the fabric or the needle hitting a pin. Relax your hold on the fabric, and allow the feed dogs to pull it through.
How will you regulate the length of the stitches if you notice?
The length of a stitch is regulated by the thumbscrew in the slot on the front of the uprise of the machine. To LENGTHEN the stitch, loosen the thumbscrew and move the lever DOWN. To SHORTEN the stitch, loosen the thumbscrew and move the lever UP.
What are the characteristics of a good stitches?
CHARACTERISTICS OF GOOD STITCHES
- The length of stitch is proportioned to the texture of the fabric.
- The stitches are the same in length.
- The stitches appear the same on both right and wrong sides of the fabric.
- The stitching follows the intended line smoothly and accurately.