How do you make a number 3 balloon?
To create the number 3 shape, you could make to half circles, and then tape them together in the middle with duct tape. After that you’d add your 4 balloon clusters to the frame. I found this video which shows the principle quite nicely, only that it is about making a letter (E) out of balloons.
How do I print large numbers?
Click the “Font Size” drop-down menu, type “72” and press “Enter.” Check how much of the page each number takes up. Increase or decrease the font size depending on how much space it takes up. Click “Print” on the menu toolbar, then “Print” again to print your large numbers.
How do I make large numbers in Word?
To increase the size of numbers in a Microsoft Word document, select the numbers, then select a font size from the drop-down menu above the Font heading on the Home tab. The largest size available on the menu is 72, but you can enter a larger font size.
How do you stick balloons to foam board?
Foam Board Option
Add your largest balloons first, then fill in the gaps with the smaller ones. You can do this in one of two ways: either by gluing the balloons directly onto the wall, or by gluing each balloon to the previous adjoining balloon. The more balloons you add the less of the foam board you will see.
How many balloons does it take to fill a mosaic?
100 – 12″ balloons from the kit. 30 – 5″ balloons from the kit. I actually could’ve used more 5″ balloons to fill in the smaller gaps.
How do you show number balloons?
Use Double-sided tape to display foil balloons is simple and easy. Tear off small sections of the tape and stick on high points of the wrong side of the balloons, then tear off the backing tape, slightly press the balloons so that they will stick on the wall.
How do you fill the number balloons?
Instructions There is a small valve or opening in the “tail” of the balloon. Slide this opening onto the nozzle of the helium tank or balloon pump until you have a tight fit. Hold the neck of the balloon firmly around the nozzle with one hand and press on the nozzle to release the helium into your balloon.